Modulation

Chorus

A stereo chorus effect with optional tempo-sync.

The following controls are provided:

Sync - switch between frequency (off) and tempo-based timing (on).

Rate - set the modulation rate from 0.01 Hz to 20 kHz or 8/1 to 1/32T according to the Sync setting.

Delay - set the base delay applied to the input signal from 1 ms to 50 ms.

Range - set the amount by which the delay is modulated from 0 to 100%.

Depth - set the dry/wet balance of the output from all dry (0) to all wet (100%).

Flanger

A stereo flanger with optional tempo-sync.

The following controls are provided:

Sync - switch between frequency (off) and tempo-based timing (on).

Rate - set the modulation rate from 0.1 Hz to 20 Hz or 8/1 to 1/32T according to the Sync setting.

Delay - set the base delay applied to the input signal from 0.1 ms to 10 ms

Range - set the amount by which the delay is modulated from 0 to 100%.

Feedback - set the amount of feedback from 0 to 100%

Depth - set the dry/wet balance of the output from all dry (0) to all wet (100%).

Phaser

A stereo, multi-stage phaser with optional tempo-sync.

The following controls are provided:

Sync - switch between frequency (off) and tempo-based timing (on).

Rate - set the modulation rate from 0.01 Hz to 10 Hz or 8/1 to 1/32T according to the Sync setting.

Range - set the upper limit of the sweep range from 200 Hz to 2 kHz. The lower limit is 100 Hz.

Stages - set the number of stages to 2, 4, 6, 8, 10 or 12.

Feedback - set the amount of feedback applied from 0 to 100%.

Depth - set the dry/wet balance of the output from all dry (0) to all wet (100%).

Tremolo

A volume-modulation effect with optional tempo-sync.

The following controls are provided:

Modulation Selector - set the modulation type to sine, sawtooth or square waveforms.

Sync - switch between frequency (off) and tempo-based timing (on).

Rate - set the modulation rate from 0.5 Hz to 20 Hz or 2/1 to 1/32T according to the Sync setting.

Depth - set the amount of modulation applied from -100% to +100%. Negative amounts use an inverted waveform affecting the phase and for the sawtooth wave the shape of the modulation applied.

AutoPan

An auto-panning modulation effect with optional tempo-sync and width control.

The following controls are provided:

Modulation Selector - set the modulation type to sine, sawtooth or square waveforms.

Sync - switch between frequency (off) and tempo-based timing (on).

Rate - set the modulation rate from 0.1 Hz to 10 Hz or 8/1 to 1/8 according to the Sync setting.

Depth - set the amount of modulation applied from -100% to +100%. Negative amounts use an inverted waveform to apply the panning in an opposing direction.

RingMod

A ring-modulation effect.

The following controls are provided:

Rate - set the frequency of the amplitude modulation applied to the input from 2 Hz to 2 kHz.

Mix - set the dry/wet balance of the output from all dry (0) to all wet (100%).